- How do I reset my Rockville amp?
- Why is my amp not putting out sound?
- Why does my Rockville amp go into protect mode?
How do I reset my Rockville amp?
You must reset the amplifier by turning it OFF and then ON again by the Remote power connection after correcting a diagnostic condition. (Turn your radio off and then on again.) Clipping or total shutdown may also be a result of a bad ground connection or loose ground.
Why is my amp not putting out sound?
If No Sound Is Coming From Your Speakers
If the amp turns on, make sure that it receives an input from the head unit. ... If the amp drives that, the problem is with the speakers or wiring. If you still don't get any sound, the amplifier might be faulty.
Why does my Rockville amp go into protect mode?
Overheating. Some amps go into protect mode if they get too hot, which can prevent a permanent failure. ... If the amp is located underneath the seats, or in another confined space, that may cause it to overheat. One way to test this is to set up a 12v fan so that it blows air over the amp.