Where to put guitar Harmonizer in effects chain?

With a harmonizer pedal, it belongs to the pitch shifter group. So that means it should be placed somewhere at the beginning of the signal chain. To be more specific, it is suggested to be placed after the compression for a more accurate note.

1. Where do I put my multi effects pedal in my chain?
2. Where does tremolo go in chain?
3. Where do you place a noise gate in a signal chain?

Where do I put my multi effects pedal in my chain?

Typically, most players will find that compression, boost, and dirt pedals are best suited to being first in the signal chain, or perhaps second, right after a wah or tuner (both pedals that may be easily replaced by a multi-effect, by the way). This is a good place to start, as it produces very dependable results.

Where does tremolo go in chain?

The most common advice is to place your tremolo pedal at the end of your signal chain as you want it to magnify and vary the volume of the entire signal. But there are no limitations to the options that you can select for a suitable position. The tremolo pedals can be placed to satisfy your own needs.

Where do you place a noise gate in a signal chain?

Where does a noise gate go in your signal chain? In some ways, this is subjective. Naturally, you'll want to place the noise gate wherever the noise is, for example after your fuzz pedal. It's most common, however, to put it at the end of your chain but before any ambient pedals such as delay and reverb.